Optex SC-U1, Operation Manual

Page: 42 / 92

42
Relay Setting
● Trigger
For alarm output, set High Alarm (upper limit trigger) or Low Alarm (lower limit trigger).
Set a measurement value to activate the On delay.
In the setting item selection menu, select
[Trigger] using , and press .
In the setting item selection menu,
select [Active Level] using
,
and press .
1
1
5HOD\6HWWLQJ
&+
2XWSXW,WHPࠉࠉ+\VWHUHVLV
㸱 '2ࠉࠉࠉPJ/
7ULJJHUࠉࠉࠉ 2Q'HOD\
+LJK$ODUP ࠉࠉࠉࠉ2))
$FWLYH/HYHOࠉࠉ2II'HOD\
PJ/ࠉࠉࠉࠉ2))
5HOD\6HWWLQJ
&+
2XWSXW,WHPࠉࠉ+\VWHUHVLV
㸱 '2ࠉࠉࠉPJ/
7ULJJHUࠉࠉࠉࠉ2Q'HOD\
+LJK$ODUPࠉࠉࠉࠉ2))
$FWLYH/HYHOࠉ ࠉ2II'HOD\
PJ/ ࠉࠉࠉࠉ2))
Select [High Alarm] or [Low Alarm] using
, and press .
Select a digit by and value by
, and press .
• High Alarm (upper limit trigger)
Alarm condition is met when a measurement value
exceeds the active level
• Low Alarm (lower limit trigger)
Alarm condition is met when a measurement value
falls under the active level
The display returns to the setting item selection menu.
The display returns to the setting item selection menu.
2
2
5HOD\6HWWLQJ
&+ 㸱 '2'26
7ULJJHU6HWWLQJ
+LJK$ODUP
/RZ$ODUP
5HOD\6HWWLQJ
&+ 㸱 '2'26
$FWLYH/HYHO6HWWLQJ
ࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉPJ/
● Active Level
When a value outside the set range is entered, a short
beep sounds. The setting range varies depending
on the measurement item. Refer to each sensor's
instruction manual.
Press
simultaneously while entering a value
to reset to the factory default setting.
By pressing or , the value returns to the one
before changing it.