![background image](http://html.mh-extra.com/html/omron/zs-l/zs-l_user-manual_1633386056.webp)
3-4
Se
c
tion 3
SE
T
U
P
ZS-L
User’s Manual
Section 3
About Setup
About Setup
The ZS-L Series can be set up on the Sensor Controller or on the SmartMonitor ZS
software utility.
This manual describes setup on the Sensor Controller.
For details on how to set up the ZS-L Series on SmartMonitor ZS, refer to Help contained
on the SmartMonitor ZS CD-ROM.
Basic Knowledge for Operation
The following describes basic operation of the Sensor Controller before you set up the ZS-
L Series.
■
Switching Modes
The ZS-L Series has the following 3 operating modes. Switch to the desired mode
before you start operation.
To switch the operating mode, use the Mode Switch.
When you switch the operating mode after changing the measurement conditions, you will be
prompted to save the settings. Save the settings as required. If you turn off the Sensor Controller
without saving these settings, the newly set measurement conditions will be cleared from memory.
You can also save all the settings later on.
Saving setup data p.3-35
Mode
Description
RUN mode
Normal operating mode
TEACH mode
This mode is for setting the judgment threshold values.
FUN mode
Mode for setting the measurement conditions
TEACH
RUN
FUN
Summary of Contents for ZS-L -
