2-8
S
ect
io
n
2
IN
STALLATION &
CONNECTI
O
N
ZS-L
User’s Manual
Section 2
About the I/O cable
(7) OUT4 (BUSY output)
This turns ON during sampling with the hold function enabled. It allows you to check
whether or not the self-trigger is functioning correctly. It also turns ON during bank
switching.
(8) Linear output
The linear output outputs a current or voltage in accordance with the measured value.
(9) Linear GND
The linear GND terminal is the 0V terminal for the linear output.
This ground wire must be grounded separately from the other ground wires.
Always ground the linear output terminal even when linear output is not used.
(10) to (13) IN0 to IN3
The following input signal assignments can be selected.
• Signal assignments
I/O Assignment Settings p.4-7
• Signal functions
External I/O timing chart p.4-9
Signal
When [Standard] is selected (default)
When [Bank] is selected
IN0
External trigger (timing) input
Bank input A
IN1
Reset input
Bank input B
IN2
LD-OFF input
LD-OFF input
IN3
Zero reset input
Zero reset input
Signal Name
Description
External trigger (timing) input
This timing input is for signal input from external devices. Use it for hold
function timing.
Reset input
This resets all executing measurements and outputs. While a reset is
being input, judgment output conforms to the non-measurement set-
ting. If this reset input switches ON while the hold function is used, the
state in effect before the hold function was set will be restored.
LD-OFF input
If this LD-OFF signal is set to ON, the laser will stop emission, causing
a light amount error. While LD-OFF is being input, judgment output
conforms to the non-measurement setting.
Zero reset input
This is used to execute and clear a zero reset.
Bank input A, B
This is used for switching banks. Specify the bank No. in combinations
of A and B.
Summary of Contents for ZS-L -
