Specifications and External Dimensions
170
ZG User’s Manual
*1:
The measurement cycle stated here is for when the FIXED/AUTO sensitivity modes are selected. The
measurement cycle increases when the MULTI sensitivity mode is selected and according to other settings.
Check the actual measurement cycle by the ECO monitor in the RUN mode.
Controller signal statuses
Input specifications
Output specifications
*1:
For details, see ”Chapter 4 CONNECTION WITH EXTERNAL DEVICE“ p.109.
Operation
environment
robustness
Ambient temperature Operating: 0 to +50 °C Storage: -15 to +60 °C
(with no icing or condensation)
Ambient humidity
Operating and storage: 35% to 85%
Degree of protection IP20 (IEC60529)
Vibration resistance
(durability)
Vibration frequency: 10 to 150 Hz Single-amplitude: 0.35 mm
Acceleration: 50 m/s
2
10 times for 8 minutes
Shock resistance
(destructive)
150 m/s
2
3 times each in 6 directions (up/down, left/right, forward/
backward)
Material
Case: Polycarbonate (PC), Cable sheath: heat-resistant PVC
Cable length
2 m
Weight
Approx. 300 g (including cable) (when packaged: approx. 450 g)
Accessories
ZG-WDC_1: ferrite core (large) (1 p'ce), Insure Lock (1 p'ce), Instruction Sheet
ZG-WDC_1A: ferrite core (large) (1 p'ce), ferrite core (small) (2 p'ces),
Insure Lock (1 p'ce), Instruction Sheet, setup software (CD-ROM), USB
cable
FUN mode
ADJ mode
RUN mode
Continuous
(trigger disabled)
Trigger
LD-OFF
Enabled
Enabled
Enabled
Enabled
ZERO-RESET
Disabled
Disabled
Enabled
Enabled
TRIG
Disabled
Disabled
Disabled
Enabled
FUN mode
ADJ mode
RUN mode
Continuous
(trigger disabled)
Trigger
ALL-PASS
OFF
OFF
ON/OFF
ON/OFF
NG
OFF
OFF
ON/OFF
ON/OFF
ERROR
OFF
OFF
ON/OFF
ON/OFF
GATE
OFF
OFF
ON/OFF
ON/OFF
ENABLE
OFF
OFF
ON
ON/OFF
Analog
Clamp value
Clamp value
Measurement value/clamp value
Parallel Output Unit
OFF
OFF
Measurement value/status output
(*1)
Item
ZG-WDC11/WDC11A
ZG-WDC41/WDC41A
Summary of Contents for ZG -
