4
.
Overview
4
4. Overview
This document describes the procedure for connecting WAGO-I/O-SYSTEM Fieldbus Coupler
(750-series) of WAGO Kontakttechnik GmbH & Co. KG (hereinafter referred to as WAGO) to
NJ-series Machine Automation Controller (hereinafter referred to as Controller) of OMRON
Corporation (hereinafter referred to as OMRON) via EtherCAT and provides the procedure for
checking their connection. Refer to
Section 6 EtherCAT Settings
and
Section 7. EtherCAT
Connection Procedure
to understand the setting method and key points to operate PDO
communications of EtherCAT.
5. Applicable Devices and Device Configuration
5.1. Applicable Devices
The applicable devices are as follows:
Manufacturer
Name
Model
OMRON
NJ-series CPU Unit
NJ501-[][][][]
NJ301-[][][][]
WAGO
WAGO-I/O-SYSTEM Fieldbus Coupler with ID
Address Selection Switch
750-354/000-001
Precautions for Correct Use
As applicable devices above, the devices with the models and versions listed in
Section 5.2.
are actually used in this document to describe the procedure for connecting devices and
checking the connection.
You cannot use devices with versions lower than the versions listed in
Section 5.2.
To use the above devices with versions not listed in
Section 5.2
or versions higher than those
listed in
Section 5.2
, check the differences in the specifications by referring to the manuals
before operating the devices.
Additional Information
This document describes the procedure to establish the network connection. Except for the
connection procedure, it does not provide information on operation, installation or wiring
method. It also does not describe the functionality or operation of the devices. Refer to the
manuals or contact the device manufacturer.
(WAGO http://www.wago.com )
This URL is the latest address at the time of this document creation. Contact each device
manufacturer for the latest information.
Summary of Contents for WAGO-I/O-SYSTEM
Page 32: ...2014 0414 P594 E1 01...