7
．
EtherNet/IP Connection Procedure
12
7. EtherNet/IP Connection Procedure
This section describes the procedures for connecting the netTAP and the Controller via
EtherNet/IP. The settings for DeviceNet communications to the netTAP are described in
7.2.
Hilscher netTAP Setup
.
The procedure for setting up the Controller in this guide is based on the factory default
settings. For the initialization, refer to
Section 8. Initialization Method
.
7.1. Work Flow
Take the following steps to connect the netTAP and the Controller via EtherNet/IP and to
perform tag data links.
7.2. Hilscher netTAP Setup
Set up the Hilscher netTAP.
↓
7.2.1. Hardware Settings
Check the position of the connectors and connect
the cables.
↓
7.2.2. Gateway Settings
Set parameters for the netTAP (gateway
configuration).
↓
7.2.3. EtherNet/IP Communications
Settings
Set parameters for EtherNet/IP Communications.
↓
7.2.4. DeviceNet Communications
Settings
Set parameters for DeviceNet Communications.
↓
7.2.5. Signal Mapping
Map the gateway signals (I/O data).
↓
7.2.6. Downloading the Configuration
Parameter Data
Download the configuration parameter data to the
netTAP.
↓
7.3. Controller Setup
Set up the Controller.
↓
7.3.1. IP Address Settings
Start Sysmac Studio and set the IP address of the
Controller.
↓
7.3.2. Global Variable Settings
Set global variables to use for tag data links, and
create and export a CSV file in order to use the
variables as tags with Network Configurator.
↓
7.3.3. Transferring the Project Data
Go online with Sysmac Studio and transfer the
project data to the Controller.
↓
Summary of Contents for sysmac EtherNet/IP NJ Series
Page 68: ...2018 0718 0718 P708 E1 01 ...