Omron SYSMAC C200H, Installation Manual

Page: 115 / 230

Appendix A
Standard Models
101
Head Unit
Name Specifications Model number
Head Unit (a set consisting of light
source unit and connector adapter)
(see note)
SYSMAC BUS:
C200H-RM001-PV1
C200H-RT001/RT002-P
S3200-CAT2822
SYSMAC NET:
S3200-LSU03-V1/LSU03-01E
C500-SNT31-V4
3G8FX-TM111
3G8SX-TM111
S3200-CAT3202
Note: Use a proper Head Unit model for the optical module to be used. If two types of optical modules (unit type
and board type) are used, order an Optical Power Tester plus a proper Head Unit model.
Master Fiber Set
Name Specifications Model number
Master Fiber Set (1 m) S3200-CAT3202 (SYSMAC NET, NSB, NSU, Bridge) S3200-CAT3201
S3200-CAT2002/CAT2702 (SYSMAC NET, SYSMAC
LINK) S3200-CAT2001H
S3200-CAT2822 (SYSMAC BUS) S3200-CAT2821
Note 1. The Master Fiber Set is used in combination with the Optical Power Tester to check the optical levels of
optical fiber cables connected to optical fiber cable connectors.
2. Optical fiber cables must be prepared and connected by specialists.
3. The Optical Power Tester, Head Unit, Master Fiber set, and Optical Fiber Assembling Tool are required
to connect optical fiber cables.
SYSMAC LINK/SYSMAC NET Link Optical Fiber Products
Optical Fiber Cables for SYSMAC LINK and SYSMAC NET Link Systems
Use hard-plastic-clad quartz optical fiber (H-PCF) cables for SYSMAC LINK and SYSMAC NET Link Systems.
H-PCF cables are available with connectors already attached, or cables and connectors can be purchased sepa-
rately and assembled by the user. Refer to the
System Manual for the SYSMAC LINK or SYSMAC NET Link Sys-
tems for assembly procedures. Models numbers for H-PCF cables with connecters attached are provided in the
following illustration.
S3200-CN
jjj
-
jj
-
jj
Cable length
201: 2 m
501: 5 m
102: 10 m
152: 15 m
202: 20 m
Blank: Over 20 m
(Specify.)
Connectors
20-25: Full-lock connector on
one end, half-lock con-
nector on other end.
25-25: Half-lock connectors
on both ends.
Model Numbers for H-PCF Cables with Connectors
An Optical Fiber Cable Bracket must be used to support an optical fiber cable connected to the C200HS-SNT32
SYSMAC NET Link Unit or C200HW-SLK13/SLK14 SYSMAC LINK Unit.
User optical fiber cables with both tension members and power supply lines.
The following half-lock connector is used and connects to the C200HS SYSMAC LINK and SYSMAC NET Link
Units: S3200-COCF2511.
The following full-lock connector is used and connects to the CV500 SYSMAC LINK and SYSMAC NET Link Units
and the C1000H SYSMAC LINK Unit: S3200-COCF2011. This full-lock connector cannot be connected to the
C200HS SYSMAC LINK and SYSMAC NET Link Units.
The above connectors cannot be used for the C500 SYSMAC NET Link Unit, cable relays, and the SYSMAC NET
Link Network Service Board. Refer to the
SYSMAC NET Link System Manual for further information.