Section 5 Troubleshooting and Maintenance
5-2 Error Messages
5-17
NS Series Programming Manual
Message Cause
Possible
countermeasure
Cannot cancel error by the
following case:
•
Operation mode is not in
program mode.
•
Cause of error at host side is
not yet removed.
Not in program mode.
Cause of error not cleared on
host side.
Change to program mode.
Clear error on host side.
Writing to this memory is not
possible.
Tried to write to AR.
AR is write prohibited.
Select another memory area.
Cannot write in during RUN
mode.
Tried to write in RUN mode.
Change to program or monitor mode.
Force ON/OFF is not possible
with this address type.
Tried to force ON/OFF DM or
EM.
Select another memory area.
Cannot connect to this PLC
model.
Tried to connect a PLC that
cannot be connected to de-
vice monitor.
Check the PLC model and change to
permissible PLC type.
No project data.
Tried to change settings even
though there is no project
data.
Download the project data.
Old password is NOT correct.
Input incorrect previous
password when changing
password.
Use CX-Designer to check the password
and input the correct password.
Password input in the confirma-
tion does NOT match with the
New Password.
Input the incorrect new pass-
word to the Confirmation input
field when changing pass-
word.
Enter the new password again.
Failed to save data to CSV file in
a Memory Card.
Check the Memory Card.
A Memory Card is not
inserted or the Card is not
one supported by the PT.
Check to see if a Memory Card is inserted,
replace it if necessary, and try to save the
data again.
Changing value is set as
Disable so that the value cannot
be changed.
Device Monitor value modifi-
cation is disabled.
Use the PT Settings Tab Page under the
System Menu to enable changes to the
values.
Changing value is set as
Disable so that the Mode cannot
be changed.
Device Monitor value modifi-
cation is disabled.
Use the PT Settings Tab Page under the
System Menu to enable changes to the
values.
Failed to delete the file.
The file is a read-only file.
Clear the read-only setting.
Printer error
The printer cable is not con-
nected, the printer power is
OFF, or a printer error
occurred.
Make sure the cable is properly connected
and the power is ON. Eliminate any printer
hardware errors, such as an empty paper
tray or empty ink cartridge.
Failed to stop the Memory Card.
It is not ready to be removed.
The
Remove
Button was
pressed while the Memory
Card was being accessed.
Wait until the Memory Card stops being
accessed, and then press the
Remove
Button again to remove the Memory Card.
Summary of Contents for NS -
