Section 5 Troubleshooting and Maintenance
5-1 Errors
5-5
NS Series Programming Manual
Symptoms Cause
Possible
countermeasure
Communications error.
Check the communications settings again.
Some objects set
for the screen not
displayed.
A
No display
flag has
turned ON for an object
control flag.
Use the following method to set the control flags to
Display
for the objects not displayed.
Set the object properties on the Control Flag Tab Page to
Display
using CX-Designer.
Set the contents of the indirect address for the object control
flag to
ON
for bits and
1
for words.
Log graph display
does not match
actual log timing.
Address set as log timing
event turning ON/OFF at
high speed.
Lengthen the ON/OFF cycle for the event address.
Cannot input
numerals.
Maximum/minimum limit
check function operating
for numeral input.
Check the maximum and minimum limits for screen data
numeral input and adjust if necessary.
A
Disable input
flag has
been set for an object
control flag.
Use the following method to set the control flags to
Enable
input
.
Set the object properties on the Control Flag Tab Page to
Enable input
using CX-Designer.
Set contents of indirect address for object control flag to ON.
Password set.
Enter the password in the displayed Password Dialog Box.
Cannot input to
some functional
objects.
Input objects overlapping.
Some input objects do not operate correctly if they are over-
lapping. Arrange the input objects so that they do not overlap
when creating screens.
Set system memory bit $SB19 to OFF.
Touch the screen and enter the password for clearing prohibit
input into the displayed dialog box.
Cannot input to
any functional
object.
In prohibit input mode.
Manipulate the Touch Switch Lock Control Flag from the host
to allow input.
Nothing displayed
on list selection or
bitmap objects.
No reference file.
Use the CX-Designer (on the personal computer) to check
that the reference file exists in the folder where project data is
stored and transfer the screen data to the PT again.
More than the maximum
number of lines has been
specified for first line of list
selection.
Set a line number within the maximum number of lines.
Summary of Contents for NS -
