Omron FH-2 Series, Hardware Setup Manual, Page: 65 / 244

Component Names and Functions
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(K)
(L)
(J)
Connector name Description
(A) SD memory card
installation con-
nector Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be affected or data
may be destroyed.
(B) Ethernet connec-
tor Connect an Ethernet device.
Upper port :
Ethernet port
Lower port :
Ethernet port, EtherNet/IP port, and PROFINET port are
sharing use.
(C) USB connector Connect a USB device.
Do not plug or unplug it during measurement. Otherwise measurement time may
be affected or data may be destroyed.
Left ports: USB2.0
Right ports: USB3.0
The USB3.0 interface has a higher bus power supply
capability than the USB2.0 interface, and you can expect more
stable operation with it.
Also, when used in combination with a USB3.0 device, you can expect higher
transfer speed than USB2.0.
Be sure to give priority to using the USB3.0 interface.
(D) RS-232C connec-
tor Connect an external device such as a PLC.
(E) DVI-I connector Connect a monitor.
(F) I/O (Parallel) con-
nector (control
lines, data lines) Connect the controller to external devices such as a sync sensor and PLC.
(G) EtherCAT address
setup volume Used to set a station address (00 to 99) as an EtherCAT communication device.
(H) EtherCAT commu-
nication connector
(IN) Connect the opposed EtherCAT device.
3 Configuration
3-7
FH Series Vision System Hardware Setup Manual (Z366-E1)
3-1 Sensor Controller
3
3-1-1
FH-2000/FH-5000 Series