65
Environment-resistive Slave Units
Section 5-2
Setting the Node
Address
The rotary switches are used to set the lower digits of the IP address.
Rotary Switch Settings
00 hex:
BOOTP or tool setting enabled (factory setting)
01 to FE hex: Setting on rotary switches is lower 8 bits of IP address. (De-
fault setting of upper 24 bits: 192.168.250.)
FF hex:
Restores default setting.
(To restore the default setting, set the switches to FF hex, cycle the power
supply, and then set the switches to 00 hex.)
Internal Circuits
8-A
Lit yellow.
Input 4 is ON.
Not lit.
Input 14 is OFF.
Lit red.
Connector 8 is short-circuited.
Flashing red.
Connector 8 is disconnected.
8-B
Lit yellow.
Input 15 is ON.
Not lit.
Input 15 is OFF.
Lit red.
---
Flashing red.
---
Indicator
Color
Status
Meaning (main error)
Setting method
Two hexadecimal digits
Setting range
01 to FE
Photocoupler
I/O indicator
1
5
3
4
1
2
4
3
I/O indicator
Photocoupler
DC-DC
converter
(non-
isolated)
Short-circuit or
disconnection
detection circuit
Internal
circuits
Pulse
trans-
former
2
Summary of Contents for ERT1 Series
