17
Overview of System Startup Procedure
Section 2-1
Example 1: Displaying IP Address 192.168.250.10
2.
Set the address of the EtherNet/IP Unit
Refer to
Common Procedure 4. Connecting the Network Online
. For de-
tails on setting IP addresses using the Network Configurator (CIP messag-
es), refer to
Common Procedure 6-2
. When setting the IP addresses using
a BOOTP server, refer to
Common Procedure 6-3
.
3.
Operation after Completing the Setting
If an F3 error occurs after setting the IP address, set the node switches on
the front of the EtherNet/IP Unit to the hexadecimal equivalent of the low-
order digit of the IP address.
Common Procedure 6-2. Setting IP Addresses Using the Network Configurator
1,2,3...
1.
Select
Tools
−
Setup TCP/IP Configuration
to open the Setup TCP/IP
Configuration Dialog Box.
2.
Input the IP address of the device that is to be changed in the
Target IP
Address Box
.
Click the
Get from the Device
Button to get the current settings.
Change the IP address or subnet mask, and then click the
Set to the De-
vice
Button. The new settings will be written to the device.
The IP address is displayed in decimal, flowing from right to left.
Summary of Contents for ERT1 Series
