Omron E5AF, Operation Manual

Page: 24 / 82

(
3--2 Before Applying Power
Before switching on power to the E5AF, set the switches by following the pro-
cedures below.
Disconnect the communications cable from the E5AF. Lift the internal mecha-
nism while pressing the hook at the bottom of the front panel.
Communications
cable Hook
Pull out the internal mechanism while
holding down the hook with your finger.
To mount the Output Unit, insert it in the direction shown by the arrow. To re-
move it, first remove the communications board (A) by pulling it in the direc-
tion of the arrow (
). Then remove the Output Unit.
Mount the Output Unit with
this mark facing the direction
indicated by the arrow.
If the relay for the output selector switch (SW202), the
SSR, or the Voltage Output Unit is installed, set the out-
put selector switch to PUL (pulse). If the Current Output
Unit is installed, set the switch to CUR (current).
(A)
Refer to the E5AF instruction manual or the operating procedures in the da-
tasheet for detailed information about setting the switches shown in the fol-
lowing diagram.
Key Protect (SW101)
Output selector (SW202, OUT)
Alarm 2 mode selector (SW203, ALM2)
Alarm 1 mode selector (SW205, ALM1)
Function selector (SW201, FUNCTION)
Temperature sensor selector (SW206, INPUT)
Opening the E5AF
Mounting or Removing the
Output Unit
Function Switches
Section 3--2