65
Overview of RS-422 Communication Unit
Section 4-1
The following types of CompoWay/F messages communications are sup-
ported.
Note The following table lists the CompoWay/F commands that can be
sent to the Communication Unit.
Note When using a PLC as the master to send CompoWay/F message communi-
cations, CompoWay/F commands are executed from the Serial Communica-
tions Board or Unit using the following standard system protocol macros.
Operation
Communications details
Number of
Sensors
Conditions
Reading from variable area,
parameter area, and other data
Reads parameters, such as status data,
incident light levels, and thresholds.
16 max.
Not possible when
Mobile Console is
connected.
Writing to parameter area
Writes (sets) parameters, such as the maxi-
mum sensitivity and thresholds.
Operation commands
Perform operations such as teaching and
fine-tuning
Command
Details
Read from Variable
Area
Executes Read Status Data, Read Incident Light Level, Read
ON Incident Light Level, and Read OFF Incident Light Level.
Read from Parame-
ter Area
Executes Read Number of Sensors Connected, Read Thresh-
old Setting, Read Basic Settings, Read Timer Setting, Read
Hysteresis Width, Read Custom Flags, and Read Special
Flags.
Write to Parameter
Area
Executes Write Number of Sensors Connected, Write Thresh-
old Setting, Write Basic Settings, Write Timer Setting, Write
Hysteresis Width, Write Custom Flags, and Write Special
Flags.
Read Model
Attributes
Reads Communication Unit model information.
Read Controller Sta-
tus
Reads the operating status and the number of Sensors that
can communicate.
Echoback Test
Executes Echoback Test.
Operation com-
mands
Executes Adjust Maximum Sensitivity, Teach One Point,
Teach First Point, Teach Second Point, Teach First Position,
Teach Second Position, Start Zero Reset, Disable Zero
Reset, Start Flashing, Stop Flashing, Initialize Sensor Set-
tings, and Reset.
Sequence No.
Communications sequence
name
Summary
600
Send/receive with ASCII conver-
sion (with response)
Converts the data following the
specified command codes
(MRC, SRC) into ASCII and
sends it to the specified Unit.
The response is converted into
hexadecimal and stored in the
specified words.
601
Broadcast with ASCII conver-
sion (with no response)
Executes sequence number 600
as a broadcast without waiting
for a response.
Summary of Contents for E3X-CIF11
