OmniSwitch os6900, Network Configuration Manual, Page: 593 / 942

Configuring IP Multicast Switching Configuring IPMSv6 on a Switch
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 24-27
Removing an MLD Static Neighbor
To reset the port so that it is no longer an MLD static neighbor port, use the no form of the
ipv6 multicast max-group command by entering no ipv6 multicast static-neighbor , followed by vlan , a
space, the VLAN number, a space, followed by port, a space, slot number of the port, a slash ( / ), and the
port number.
For example, to remove port 10 in slot 4 with designated VLAN 2 as an MLD static neighbor you would
enter:
-> no ipv6 multicast static-neighbor vlan 2 port 4/10
Configuring and Removing an MLD Static Querier
MLD static querier ports receive MLD reports generated on the designated VLAN. Unlike MLD neighbor
ports, they do not receive all multicast streams. The following subsections describe how to configure and
remove a static querier by using the
ipv6 multicast static-querier command.
Configuring an MLD Static Querier
You can configure a port as an MLD static querier port by entering ipv6 multicast static-querier ,
followed by vlan , a space, the VLAN number (which must be between 0 and 4095), a space, followed by
port , a space, the slot number of the port, a slash ( / ), and the port number.
For example, to configure port 10 in slot 4 with designated VLAN 2 as an MLD static querier you would
enter:
-> ipv6 multicast static-querier vlan 2 port 4/10
You can also configure a link aggregation group as an MLD static querier port by entering
ipv6 multicast static-querier , followed by vlan , a space, VLAN number (which must be between 0 and
4095), a space, followed by port , a space, and the link aggregation group number.
For example, to configure link aggregation group 7 with designated VLAN 2 as a static querier you would
enter:
-> ipv6 multicast static-querier vlan 2 port 7
Removing an MLD Static Querier
To reset the port, so that it is no longer an MLD static querier port, use the no form of the
ipv6 multicast static-querier command by entering no ipv6 multicast static-querier , followed by vlan ,
a space, the VLAN number, a space, followed by port , a space, the slot number of the port, a slash ( / ), and
the port number.
For example, to remove port 10 in slot 4 with designated VLAN 2 as a static querier you would enter:
-> no ipv6 multicast static-querier vlan 2 port 4/10
Configuring and Removing an MLD Static Group
MLD static group ports receive MLD reports generated on the specified IPv6 Multicast group address.
The following subsections describe how to configure and remove an MLD static group by using the
ipv6 multicast static-group command.