61
Now enter in new option numbers for Functions 4, 5, 6. and 8. P
key is used to enter and exit from setting mode. Option numbers
are on the left of the decimal point. Function numbers are on the
right side of the decimal point. Flashing digits can be raised or
lowered
using or keys.
Use
★
key to transfer adjustment
from Function to Option column or vice versa.
If this procedure fails to produce good results, repeat observations,
calculations, and check controller setting.
STEP
11
600
180 300
120
60
30
Fixed Values
Option No.
Out
1
2
3
4
5
6
0
7
SECONDS
*
1080
*For other fixed values, refer to Table 3-4.
Using the same value of T, select option number in
Function .8
"Integral Time" table below.
5.3 PROPORTIONING TIME
Ideal Setting
The Proportional Time setting determines the cycle rate of the
output device. In the interest of long contact life, this should be the
slowest (longest setting) possible if mechanical relay output is
being used. Otherwise there is no disadvantage in using faster
settings. Refer to Figure 5-4.
Figure 5-4. Proportioning Time
Setting Too Long
(oscillates)
Summary of Contents for C9000A SERIES
Page 6: ...This page is intentionally blank iv ...
Page 76: ...70 NOTES ...
Page 90: ...84 NOTES ...
