21. Adjust the
tank drain
[1] and fill the
tank
with water above the material (if
possible).
NOTICE
To extend the life of the catcher tank, cut towards the center of the tank.
Continuous cutting at the outer edges of the cutting envelop may allow the jet
stream to wear through the sides of the catcher tank.
Figure 257
NOTE:
Cut parts under water when possible. Cutting under water lowers the noise level and
reduces the mist and splash created by the water and abrasive. Cutting under water also
helps the garnet bins collect cutting debris instead allowing the debris to settle in the tank,
which makes tank cleaning easier.
22. Close the
lid
.
23. Cut the part.
a. Click
Begin Machining
[1].
Figure 258
b. Click
Start
.
Summary of Contents for ProtoMax
Page 45: ......
