39. Click
OK
on
Machine will now traverse into position
dialog box.
Figure 292
40. Click
Continue
to start cutting.
Figure 293
If nozzle clogging continues, it may be necessary to replace the abrasive feed tube, the
mixing tube, nozzle orifice, and/or nozzle filter as one or more of these components
may be causing the problem.
Reset the Pump
Flush the Plumbing, Reset the Pump, and Test the Nozzle
The reset pump test runs a 30 second sequence to reset the pump. This test should be
done before operating the ProtoMAX for the first time, after changing the nozzle
orifice, repairing or replacing the pump, repairing any high pressure plumbing
leaks, or when required by a fault or alert message.
1. Open
MAKE
.
2. Move the
nozzle
between two
slats
.
3. Click
Test
.
4. In
Test Operations
, select
Reset Pump
, and click
Next
.
5. Click
Start Test
and check the
high-pressure plumbing
for leaks (the dialog box
closes when the test is complete).
Technical Support
Refer to the ProtoMAX website for technical support contact information.
Warranty
Contact Customer Support or go to the ProtoMAX website.
Summary of Contents for ProtoMax
Page 45: ......
