31. Connect the
abrasive tube
to the
nozzle body
.
NOTE:
If an alert or fault message is displayed, reset the pump (see
32. Attach the
nozzle splash guard
.
33. Set the
nozzle stand-off
.
34. Close the
lid
.
CAUTION
Use care when opening or closing the lid to avoid injury. Keep hand, fingers, or
body part away from the side of the table when closing the lid. Never let the lid
free-fall.
To continue cutting the part, using MAKE:
35. Click
Go Home
in the
Path Start Home
dialogue.
Figure 289
36. Right-click
Begin Machining
.
Figure 290
37. Click
Go to Spot on Path
.
Figure 291
38. Move the cursor over the spot on the tool path slightly before the clog occurred
and left click.
Summary of Contents for ProtoMax
Page 45: ......
