3
IX73
c
13. After operation or in case of abnormality, be sure to disconnect the
power cord from the connector on the products or from the outlet.
14. To avoid potential shock hazards and burns when replacing the
lamp bulb, set the main switch to “
\
” (OFF) then disconnect the
power cord from the wall outlet in advance. Whenever you replace
the bulb during use or right after use, allow the lamp housing
c
and bulb to cool before touching.
Designated bulb
12V100WHAL-L (PHILIPS 7724)
15. Do not permit tools or metal fragments to get into air vents, or other
apertures. Doing so could cause failure of the microscope or electric
shock to the user.
16. The standard service life of the lamp housing is eight (8) years of use
or 20,000 hours of total power ON period, whichever is the shorter
period. For details, see the Inspection Sheet on page 65.
17. During the fluorescent observation, be sure to attach the antiglare
plate to the microscope to protect your eyes.
18. If you feel bright during observation through eyepieces, darken the
illumination light by adjusting the brightness of the light source or
using the ND filter. Use the equipment according to the regulations
for workers health and safety, if any.
– Europe: 2006/25/EC Directive for protecting workers from risks
caused by physical factors (artificial optical radiation).
19. Do not look directly at the light from the objective lens or the specu-
lar reflection light of the specimen.
20. Be careful invisible wavelength light (ultraviolet or infrared) may be
emitted depending on illumination methods.
21. If the skin is exposed to the light from the objective lens for a long
time, it may cause burns. Be sure to avoid it.
22. Do not place flammable gas or liquid close to the light from the
objective lens. It may cause fire.
23. This device complies with the emission and immunity requirements
described in IEC61326 series.
24. The electromagnetic environment should be evaluated prior to op-
eration of this device. Do not use this device in close proximity to the
sources of strong electromagnetic radiation to prevent interference
with the proper operation.
25. Always use the power cord provided by Olympus. If no power cord
is provided, please select the proper power cord by referring to the
section “PROPER SELECTION OF THE POWER CORD” at the end
of this instruction manual. If the proper power cord is not used, the
safety and EMC performance of the device can not be assured.
26 Always connect the power cord correctly and ensure that the
grounding terminal of the device and that of the wall outlet are prop-
erly connected. If the device is not grounded, our intended electric
safety and EMC performance of the device can not be assured.
27. It is discommended to stare at the light directly from the LED light
source composed in this product for long hours as this could dam-
age your eye. Use the equipment in accordance with the regulations
for Workers Health and Safety, if any.