24
1
Starting and exiting the system
Exiting the system
Press the [Turn Off System] button D in the upper right area of the
control window. The system is terminated and the power of DP2-AOU
turns OFF. (Time taken to exit the system: approximately 10 sec.)
The LED B of DP2-AOU and the LED C of the camera head turn OFF.
· You can also exit the system by pressing the main switch A
of DP2-AOU.
In this case, be careful not to long-press (press continuously
for 4 or more seconds) the main switch A .
If you long-press the main switch to turn OFF the power,
DP2-AOU will be terminated forcibly and the various settings or
the scale function may not be saved.
· In order to protect the system, exit the system as much as
possible when the system is not in use.
If the power of the camera head is turned OFF
while operating
DP2-AOU
Set the main switch of DP2-AOU to ON to energize the camera
head.
While operating DP2-AOU, if the interface cable is accidentally
disconnected, the power of the camera head is turned OFF, the
camera head becomes in the unconnected status and an error
message appears. In this case, press the main switch of DP2-AOU
to exit the system. Then, connect the interface cable again and
press the main switch of DP2-AOU to restart the system.
1
TIP
A
B
D
Starting the system
Press the main switch A of DP2-AOU to turn ON the power.
The system starts and the LED B of DP2-AOU and the LED C of the
camera head turn ON. The control window is displayed on the display.
(Time taken to start the system: approximately 30 sec.)
If the system is used for long hours without exiting the
system, the operation of DP2-AOU may become unstable. It is
recommended to exit the system approximately once a week
to protect the system.
1
TIP
C
