3H3
1-2-20
16. Make the following seven connections.
Top: 2-pin power connector and 2-pin motor connector; 6-pin power connector and 6-pin sensor connector
Center: 4-pin power connector and YC1 of punch PWB; 6-pin power connector and YC3 of punch PWB;
9-pin power connector and YC2 of punch PWB
Bottom: 2-pin power connector and 2-pin finisher power connector; 9-pin power connector and 9-pin finisher
power connector
17. Secure wires at one location with wire saddle.
18. Secure wires with clamp and fix with M4 x 8 tap Tight S screw.
19. Fasten the snap-on band on core A to the hole on the finisher frame.
20. Fasten the snap-on band on core B to the hole on the finisher frame.
21. Refit the rear cover.
Figure 1-2-51
22. Plug the power cable into a wall outlet and
turn the machine on from the main power
switch.
23. Adjust the centering punch-holes (see page
1-5-12).
24. Set margin from the leading edge to punch
holes (see page 1-5-13).
Clamp
M4 x 8 tap
Tight S screw
Wire
saddle
Core A
Core B
6-pin
connector
2-pin
connector
YC1
YC3
YC1
9-pin
connector
2-pin
connector
Service Manual Y1043
71
-
8