3H3-2.0
1-2-11
1-2-3 Installing the multi job tray (option)
•
Hold the frame at the front and back when removing the multi job tray from the box. Supporting the multi job tray
from the bottom can cause deformation of the film affixed to it.
•
Before installing the multi job tray, press the Power key on the operation panel to off. Make sure that the Power lamp
is off before turning off the main power switch. And then unplug the power cable from the wall outlet.
Turning off the main power switch before pressing the Power key to off may cause damage to the equipped hard
disk.
•
When installing the multi job tray and centerfold unit as a set, first install the centerfold unit and then the multi job
tray.
•
Installation should be carried out with the finisher's rear cover removed.
Procedure
1. Remove the two screws locking down the
top cover lid followed by the lid.
2. Open the upper cover and remove the nine
screws locking down the top cover followed
by the top cover.
Figure 1-2-26
3. Remove the four screws locking down the
top cover lid guide followed by the guide.
Figure 1-2-27
Screws
Screws
Screws
Top cover
Upper cover
Top cover lid
Screws
Screws
Top cover lid guide
Y1043
71-8
Service Manual