3H3
1-2-19
10. Insert the assembly tank holder into the
holes in the side of the finisher, and then
press it downwards to secure it. Next,
secure it further with the screw that was
removed in step 3. Install the screw from the
outside.
11. Connect the 3-pin connector to the 3-pin
connector inside the finisher.
12. Anchor the wires to the frame with a sup-
plied wire saddle.
Figure 1-2-48
13. Insert the intermediate tray of the finisher so
it is back to its original position, and then
install the punch waste box.
14. Close the front cover.
Figure 1-2-49
15. Insert the tab of the punch PWB into the
hole on the back of the finisher, and secure
it with the screw that was removed in step 3.
Figure 1-2-50
Tank holder
Screw
Supplied
wire saddle
3-pin connector
Punch waste box
Intermediate tray
Punch PWB
Screw
Y1043
71-8
Service Manual
