3H3
1-2-12
4. Attach the two size detection switches to the
eject stay by inserting the tabs, and lock in
place with one M3 x 5 binding screw each.
5. Connect the 3-pin connector of the size
detection switch to the connector of the fin-
isher.
Figure 1-2-28
6. Attach the bin front guide plate and bin rear
guide plate to the finisher by inserting the
claws on plates into the finisher frame and
lock in place with three M4 x 6 binding
screws each.
Figure 1-2-29
7. Attach the multi job tray to the bin front
guide plate and bin rear guide plate by
inserting the six pulleys at the tray front and
rear into the plates.
Make sure that the shading plate at the rear
of the multi job tray does not make contact
with the sensor.
Figure 1-2-30
M3 x 5
binding screw
Tab
3-pin connector
Eject stay
Size detection
switch
Bin rear
guide plate
Bin front
guide plate
M4 x 6
binding
screws
M4 x 6
binding screws
Multi job tray
Pulley
Pulleys
Pulleys
Bin front
guide plate
Bin rear
guide plate
Shading
plate
Sensor
Service Manual Y1043
71
-
8
