25
8.1.1
How to enter the Setpoint
To input a new Temperature Setpoint, touch the corresponding tab, as indicated in Figure 27 a. The
Setpoint regulation page will appear as in the Figure 27 b. You can modify the Setpoint by clicking on
+ and
–
(pointer 1 in Figure 27 b). Once you have input the new Temperature Setpoint, press
Set
(pointer 2 in Figure 27 b)
to save or
Cancel
to undo.
Figure 27. How to change the Temperature Setpoint (a
–
b).
Tip
►
After any change in the Setpoint value, UNO-CONTROLLER enters into a transient regime, the Status
Indicator and the TOP LED (see Figure 29) turn yellow (see paragraph 8.1.3). During the transient regime,
UNO-CONTROLLER will not trigger on alarm. The maximum duration of the transient regime is set by the
operator as indicated in paragraph 8.2.7.
8.1.2
Graph view
Press on the Temperature evolution chart (pointer 1 in Figure 28) to open the Graph view page. Check the
box
Grid
(pointer 2 in Figure 28), to show the grid behind the graph.
Figure 28. Graph view page (a
–
b).
