30 / 62
31 / 62
2
Select Customized to adjust the parameters
individually.
3
Auto: The length is determined by pressing
the trigger at the end of the first scan line.
1
Start the operating mode 3D Ground Scan by
tapping on the option in the App main menu.
2
Select Default to use the preset parameters
for fast scans.
6
Confirm by tapping on Start Scan.
Set the Field Length by tapping on
+
and
-
.
3
1 ft ... 160 ft: The length is defined before the
scan. All lines will stop automatically.
Toggle to set the Impulse Mode.
4
Automatic: The impulses (scan values) will
be recorded continuously without any break.
4
Manual: Every single impulse (scan value) is
recorded by pressing the trigger.
5
Parallel: Scan all lines in the same direction.
5
Zigzag: Scan all scan lines forwards and
backwards alternately.
Toggle to set the Scan Mode.
6
Confirm by pressing Start Scan.
8
Continue with section
5.7.2 Perform Default 3D Ground Scan on
page 32
,
5.7.3 Perform Zigzag 3D Ground Scan on
page 34
or
5.7.4 Perform Manual 3D Ground Scan on
page 36.
Ready to start your 3D Ground Scan.
7
Searching for a GPS Signal (if enabled).
5.7 3D GROUND SCAN
Use the operating mode 3D Ground Scan to get a detailed visualization of underground
structures and potential target objects for further analysis in Visualizer 3D Studio.
Learn more in the 3D Ground Scan Guide.
5.7.1 Configure Measurement
Make sure you have connected the Ground Scan Probe (G).
This operating mode allows vertical and horizontal (short-range)
probe orientation.