PAGE 1 OF 9
0721 IH-9467
SMOKE AND CARBON
MONOXIDE DETECTOR,
9V BATTERY
1-800-295-5510
uline.com
H-9467
NOTE: This combination smoke/CO detector
was designed to be mounted on the ceiling or
wall. It is not a tabletop device.
Find the pair of self-adhesive
labels included with this smoke/CO
detector. On each label, write in
the phone numbers of emergency
responder (like 911) and a qualified
appliance technician. Place one
label near the smoke/CO detector
and the other label in the fresh air
location that user plans to go if the
detector sounds.
CAUTION! Do not connect this unit to any other
detector or auxiliary device. It is a single-
station unit that cannot be linked to other
devices. Connecting anything else to this unit
may prevent it from working properly.
CAUTION! Do not install this unit over an
electrical junction box. Air currents around
junction boxes can prevent smoke from
reaching the sensing chamber and prevent the
unit from alarming. Only AC-powered units are
intended for installation over junction boxes.
1. If locking the battery compartment or locking the
smoke/CO detector to the mounting bracket, please
read the "Locking Features (Optional)" section.
2. Hold base firmly and twist the mounting bracket
counterclockwise to separate it from the unit.
(See Figure 1)
3. Hold the mounting bracket against the ceiling or
wall and trace around the inside of the mounting
slots. (See Figure 1)
Mounting Bracket
Mounting Slots
Figure 1
4. Use a pencil to make a mark inside each outline for
the drill holes.
5. Set the unit where it won't get covered with dust
when drilling the mounting holes.
6. Using a 3/16" drill bit, drill a hole through each pencil
mark.
7. Insert the two plastic screw anchors (included)
into the holes. Tap the screw anchors gently with a
hammer, if necessary, until they are flush with the
ceiling or wall.
INSTALLATION
TOOLS NEEDED
Pencil
Hammer
Drill
3/16" Drill Bit
Flathead Screwdriver
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
