32 / 62
33 / 62
5.7.2 Perform Default 3D Ground Scan
The default parameters Field Length: Auto | Impulse Mode: Automatic | Scan Mode: Parallel
are recommended for entry-level detector users and allow scanning in slightly sloping terrain.
3
Return to your first starting point without
scanning and take one step to the left: This
is the starting point of the second scan line.
1
Go to the starting point of the first scan line
(bottom right corner).
Press the trigger to start scanning. Start
walking as soon as you press the trigger.
2
Walk to the end of the first scan line. Press
the trigger as soon as you reach its end
to set the field length for the following lines.
The scan image will be generated line by
line to help you to follow your progress while
measuring.
The first scan lines may initially look incor-
rect. However, the inconsistent scan image
will stabilize in the course of the scan.
6
Complete the measurement by tapping on
Finish Scan .
Confirm saving with
or discard the scan
with
.
4
Press the trigger to start scanning. Start
walking as soon as you press the trigger.
Walk parallel to your first scan line and at the
same speed. The impulse sound should stop
at the end of the line.
7
If you chose to save the scan, enter the Field
Length and Field Width that you actually
measured.
8
The scan file is opened in the File Explorer –
see
.
5
Return to the last starting point and take a
step to the left (without scanning): This is the
starting point of the next scan line.
Press the trigger to start scanning and walk
at the same speed until you reach the end of
the scan line.
Repeat this to scan as many lines as you like.
