OKIDATA ML380, Service Manual

Page: 73 / 205

Page: 47
Service Guide ML380
Chapter 3 Maintenance & Disassembly
3.2.13 Carriage Frame
1. Perform these procedures: 3.2.01 , 3.2.02 , and 3.2.03 .
2. Open the supporting point A, and remove the head clamp (1).
3. Insert a screwdriver into the groove of carriage frame (2), and remove ribbon protector (3).
4. Turn the white left adjust bushing (4) to the lower end, and remove it.
5. Turn the black right adjust bushing (5) to the lower end, and remove it.
6. Turn the blue adjusting lever (6) to the lower end.
7. Slide the carriage shaft (7) to the right.
8. Remove the shaft and the adjusting lever.
9. Pull the carriage shaft in the direction of arrow B, and remove it from the carriage frame (8). Be
careful not to lose the eccentric collar (9). When installing the eccentric collar, place notched section (10)
toward the carriage shaft.
NOTE:
Perform the printhead gap adjustment procedure after installing this part.
Refer to Section 3.3 of this Service Handbook.
P/N 50702901 Clamp: Head RSPL B.2.06
P/N 53056201 Protector: Ribbon RSPL B.2.06
P/N 53330201 Frame: Carriage RSPL B.2.06
P/N 51606501 Bushing: Adjust (L) RSPL B.2.04
P/N 51606601 Bushing: Adjust (R) RSPL B.2.04
P/N 53510701 Lever: Adjust RSPL B.2.04
P/N 51110401 Shaft: Carriage RSPL B.2.04
P/N 50704601 Collar: Eccentric RSPL B.2.04
P/N N/A Code: Earth B.2.04