- 115 -
8.76 ^JM SET DOTS PER MILLIMETER
Format: ^JMn
n = Dot/mm setting
A : Once
B : Twice
Default: "DOT/MM" in the Z-MODE parameter
When omitted: This command is ignored.
* When this is set to B, the bar code is issued in twice the actual size.
(When magnification with MU command is applied, the bar code is issued in twice the magnified
size.)
*1 While the individual position and size vary depending on whether the ^MU/^JM command is placed
before or after ^FO/^FT/^LH/^LS/^LL/^PW or other command with Zebra, the position and the size
vary per label with Oki Data.
*2 Drawing running over in the horizontal direction is printed as it is with Oki Data. However, when
magnified, the portion running over the set width is not printed. In the case of Zebra, drawing
running over the set width is not printed. (If the drawing data before magnification is set to a value
exceeding the set width after magnification, the drawing data before magnification is printed without
being magnified horizontally.
*3 While the Zebra printing width is not enlarged with this command, it is enlarged with Oki Data.
*4 While magnified printing is not permitted for ^BD (UPS Maxicode) or ^BR (GS1 DataBar) with
Zebra, magnified printing is performed with Oki Data.
