- 9 -
4. START OF Z-MODE
Place the printer in Z-MODE to use the Z-MODE.
Refer to the subsequent pages for the operation example on the LE840/LE850. (Also refer to the
“LE840/LE850 Key Operation Manual”.)
NOTES
:
1. Disable Z-MODE before downloading the BASIC file.
2. Enabling or disabling the Z-MODE is also possible by using the Z-MODE setting tool.
Operation Example
Power OFF
(1) Power off state
[FEED] [PAUSE]
(2) While holding down the [FEED] and
[PAUSE] keys, turn on the printer power.
SYSTEM MODE VX. X
<1> DIAG.
<2> PARAMETER SET
<3> ADJUST SET
<4> TEST PRINT
(3) The system mode menu is displayed.
[DOWN] x 11
SYSTEM MODE VX. X
<10> RFID
<11> RTC
<12> Z-MODE
<13> USB MEMORY
(4) Press the [DOWN] key until the cursor stops
at <12>Z-MODE.
[ENTER]
(5) Press the [ENTER] key.
<12> Z-MODE
OFF
ON SETTING OFF
ON SETTING ON
(6) Z-MODE setting menu
Enable or disable the Z-MODE with the
[UP] or [DOWN] key.
[DOWN]
(7) Press the [DOWN] key.
<12> Z-MODE
OFF
ON SETTING OFF
ON SETTING ON
(8) Z-MODE is enabled but the BASIC system
mode program is not activated.
[DOWN]
(9) Press the [DOWN] key.
<12> Z-MODE
OFF
ON SETTING OFF
ON SETTING ON
(10) Z-MODE is enabled and the BASIC
system mode program is activated.
[ENTER]
(11) Press the [ENTER] key.
Display of the BASIC system mode program
(12) The BASIC system mode program is
started if it has been downloaded. The
display depends on the program.
(13) The BASIC system mode program exits.
(How to exit the program depends on the
BASIC system mode program in use.)
SYSTEM MODE VX. X
<10> RFID
<11> RTC
<12> Z-MODE
<13> USB MEMORY
(14) The system mode menu is displayed.
