- 21 -
5.11 SELECTION OF FORMAT CONVERSION
Among the Zebra commands, the ^MU command converts the format. If the ^MU command is not sent
to the printer, format conversion is performed based on this setting.
NOTE:
This is the same parameter as the FORMAT CONVERT provided in the system mode of the
Zebra printer.
5.12 SELECTION OF CONTROL PREFIX
Select a number from 0 through 9 for an applicable digit by pressing the [FEED] or [RESTART] keys.
Pressing the [PAUSE] key determines the value for the selected digit, then the cursor moves to the next
digit. (After setting a value for the last digit, the control prefix takes effect and the next parameter is
shown.)
While the Zebra ^CT and ~CT command parameters are used as control characters for command
identification, when the ^CT and ~CT commands are not sent to the printer, this setting is used as
control characters for command identification.
NOTE:
This is the same parameter as the “CONTROL PREFIX” provided in the system mode of the
Zebra printer.
NOTE:
Displayed characters may differ from the ones shown in the system mode of the Zebra printer.
•
NONE
No format conversion
•
150
→
300
150dpi to 300dpi
•
150
→
600
150dpi to 600dpi
•
200
→
600
200dpi to 600dpi
•
300
→
600
300dpi to 600dpi
FEED
RESTART
FEED
RESTART
0
1
00 to FF HEX
(00-1F HEX are not supported.)
E
F
