Oki C710, Maintenance Manual

Page: 31 / 223

43856301TH Rev.3
30 /
Oki Data CONFIDENTIAL
2. Operating instructions
Counter spec
Total printed page
number
MPT printed page
number
Tray 1 printed page
number
Tray 2 printed page
number
Tray 3 printed page
number
Color-printed page number Mono-printed page number
Description Total printed page
number Hopping page number
from MPT Hopping page number
from Tray1 Hopping page number
from Tray2 Hopping page number
from Tray3 Printed page number by
color-printing Printed page number by
mono-printing
Count method A4
conversion or size
independence Count up after passing
the writing sensor Count up if MPF(MPT)
hopping is finished Count up if Tray1
hopping is finished Count up if Tray2
hopping is finished Count up if Tray3
hopping is finished The page number is counted
up by detecting the paper
passing the fuser in color-
printing mode after the job is
finished. (1*)
The value is A4/Letter value.
Please refer to A4/ Letter
conversion table (P31). The page number is counted
up by detecting the paper
passing the fuser in mono-
printing mode after the job is
finished. (1*)
The value is A4/Letter value.
Please refer to A4/ Letter
conversion table (P31).
Operation when
paper jammed Cannot count when paper feeding (hopping) jam and feed jam are occurred.
It can count except the above-mentioned jam.
As total printed page number is counted up when the front end of the page passes the writing sensor, according to the
jam type, the feeding jam (380) is also included in the limits for counted. Cannot count if the jam is occurred before the paper passes
the fuser.
It can count if the jam is occurred after the paper passes the
fuser.
Operation for
Duplex Front/Back count(+2) Only front count (+1) Double count
If the color page and mono page exist together, the color
printing page number would be plus 1 and the mono printing
page number would be plus 1.
Reset condition None None 1)When "Format Flash ROM" of system maintenance menu
is performed.
2) When CU PCB is replaced.
3) When MENU RESET of system maintenance menu is
performed.
4) When CU PCB is replaced.
Value storage
destination PU PU PU PU PU CU CU
Menu/MenuMap
output (*2)
EngineMenuMap
output (*3) (*3) (*3) (*3) − −
*1. Count cannot be updated if the power is turned off when the jam is occurred.
*2. In the initial state MenuMap output is not available. It is possible to switch in the system maintenance menu.
*3. EngineMenuMap output divides into Engine Menu Print (the first page) and Engine EEPROM Dump Print (the last page), however, the number of paper fed from each tray is
output only to the latter one (DUMP display only).