43856301TH Rev.3
185 /
Oki Data CONFIDENTIAL
7. Troubleshooting and repair procedure
7.5.3.(6) Heavy color registration error
(6-1) Display of the message "Color adjustment is in progress" appears only short time.
Check item
Check work
Action to be taken
at NG
(6-1-1) Result of color registration error correction
Color registration
error correction
time (If a printer is
normal, it is approx.
40 seconds.)
Use the self-diagnostic mode and execute the
REG ADJUST TEST. Check the result. Error
is issued but is not displayed on the ON LINE
display.
Replace the
sensor that
causes the
error. Clean
the sensor to
remove stain.
Replace the
shutter. Replace
the PU board.
(6-1-2) Toner
Remaining amount
of toner
Check if the message "Prepare toner
replacement." or "Replace the toner." appears or
not.
Replace toner
cartridge with
new one.
(6-1-3) Color registration error detection sensor
Sensor is dirty
Is toner or paper dust attached to the sensor?
Clean the
sensor to
remove stain
(6-1-4) Color registration error detection sensor shutter
Shutter operation is
faulty
Check the shutter operation by the self-
diagnostic mode
Replace the
shutter or tune
the mechanism
(6-2) Though REG ADJUST TEST of engine maintenance function is ok, color blur occurs
Check item
Check work
Action to be taken
at NG
(6-2-1) Paper feed system
Paper feed system
of the paper running
path
Check if any obstacle exists in the paper feeding
path, that hampers smooth paper run.
Remove the
obstacle
7.5.3.(7) Entirely black print
(7-1) All black print over entire page
Check item
Check work
Action to be taken
at NG
(7-1-1) High voltage contacting condition
CH terminal
Check that the terminal coming from the printer
body contacts with the high voltage terminal that is
located on the left side of the ID unit when viewed
from the top by visual inspection.
Replace the
terminal of
printer side.
CH terminal
Check that the high voltage terminal keeps the
normal contacting condition on the high voltage
board. Open the left cover and remove the high
voltage board. Then, check that the terminal is not
installed in the abnormal installation condition.
Correct the
installation
condition of
the terminal
to the normal
condition.
ID unit terminal
Check that the high voltage terminal of the ID unit
is contacting with the Contact Assembly normally
by visual inspection. (Refer to Figure 7-3.)
Replace the ID
unit or replace
the high voltage
board or correct
the high voltage
terminal.
If any attempt
of using new
ID unit as a
trial is going
to be made,
be sure to use
the System
Maintenance
Menu FUSE
KEEP MODE.
(7-1-2) High voltage output condition
CH output
If high voltage probe is available as a
maintenance tool, open the left cover, and check
the CH output with the high voltage probe from
the soldering side of the high voltage board.
(The high voltage probe is not an ordinary
maintenance tool.)
Replace the
high voltage
board.
