OCEM AUGIER energy DIAM4200 Series, Installation & Maintenance

Page: 54 / 84

DIAM4200 ©2018 AUGIER SA.
6021642 DIAM4200 5 to 20KVA rev 1-8.docx II-54
II.2.2.19 Remote fail safe mode:
A « remote fail safe mode » can be set on the CCR. This mode is used to set a default brightness if the serial
communication or the wire control fail.
•
If the option « remote fail safe mode » is set, in case of loss of communication (timeout configurable in
the jbus table) or cut out of the wire remote link, the CCR drive a default brightness (configurable in the
jbus table).
•
If this option is set; a permanent wire link must be applied on an wire input to avoid the CCR start in
default brightness when the normal wire control i
s “off”.
Remote control board Interface board reference Permanent wire control
IEC board (without relay) 30 08928 B1 - 10
FAA board (with relays) 30 09259 B1 - 12
Adress 69, bit 5 Remote fail safe
0 No
1 Yes
Value at adress Description Default value Value
140 Timeout 250 (=5s) 0 to 65535 (*20ms)
141 Default brightness 3 0 to 7, (0 = stop, X = Brightness X)
II.2.2.20 Remote priority:
The CCR can be controled by 3 inputs :
•
Wires control
•
COM 1 input (RS422 or RS485 or MODBUS TCP)
•
COM 2 input (RS422 or RS485 or MODBUS TCP)
Standard priority:
•
The wires remote control has the highest priority. The COM 1 or COM2 control is applied when there is
no wire order (“stop” wire order).
•
The two COM 1 and COM2 have the same priority, the last order from COM 1 or COM 2 is applied.
Reverse priority :
•
The COM 1 or COM 2 control link has the highest priority. If the CCR don’t answer request for a timout
period, the wire remote control the CCR. The timeout delay is setting at the adress 226 in the jbus table.
•
The two COM 1 and COM2 have the same priority, the last order from COM 1 or COM 2 is applied.
Remote priority setting :
Adress 69, bit 3 Remote priority
0 Standard (wire control), default value
1 Reverse priority (COM1 ou COM2)
Timeout :
Value at adress Description Default value Value
140 Timeout 250 (5s) 0 to 65535 (*20ms)

The reverse priority can be choose for interface board firmware version from :V6