135
Transmitter Battery Installation
• Lightly lubricate the new Battery Cap O-ring with silicone
grease and install it onto the Battery Cap. DO NOT roll the
O-ring over the Threads, instead stretch it slightly to work it
down over the slotted end of the Cap into the Groove at the
Base of the Threads (Fig. 124).
NOTE: The O-ring must be a genuine Oceanic
part that can be purchased from an Authorized
Oceanic Dealer. Use of any other O-ring will
void the warranty.
• Place a new 3 volt, CR2, Lithium Battery (Duracell model DL-
CR2 or equivalent) positive (+) side down into the Battery
Compartment with the negative end facing up/out (Fig. 125).
• Ensure that the Battery is properly oriented and the Hatch O-
ring is evenly seated around the Battery Hatch.
• Carefully place the Battery Hatch with Spring into the Hous-
ing and turn clockwise slowly by hand to ensure proper
threading. Apply a coin and tighten until secure. The outer
surface of the Battery Hatch should be flush with the outer
surface of the Housing (Fig. 126).
Fig. 125 - Transmitter Battery
Orientation
Battery
(+) ( - )
Fig. 124 - Transmitter O-ring
Installation
Fig. 126 - Transmitter Battery
Hatch Installed
