Oce CS9160, User Manual

Page: 13 / 131

User’s Guide Océ CS9160 printer
13 AP-40790 – Rev 2.0 -23/08/2011,
• Do not connect earth cables in the following areas :
o
Gas pipes. Doing so may cause fire or an explosion.
o
Earth terminals for telephone lines or lightning rods. Doing so may cause a large flow of voltage if
lightning occurs.
o
Water pipes or faucets. If there is a plastic part in the pipe, the grounding will not work correctly.
•
Do not store combustible materials on the print platform. It could lead to fire when raising the
temperature.
•
Do not insert or drop metal or objects which are easily combustible through the openings such as fresh
air inlet into the printer. It could lead to an electric shock and fire.
• When foreign substances or liquids such as water enter the printer, do not use the printer. It could lead
to an electric shock and / or fire. Immediately switch OFF the power, disconnect the power plugs from
the electric socket, and contact your local OCÉ representative.
•
While installing optional items, be sure to Switch OFF the printer and pull out the power plugs. It could
lead to an electric shock.
• Be sure to use the power cables supplied with the printer. If other power cables are used, it could cause
an electric shock or fire.
•
Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V - 240 V). If a power
supply other than the specified voltage is used, it could cause an electric shock and fire.
•
Take power for the printer directly from the power socket (AC 100 V - 120 V or AC 220 V - 240 V). Do
not use complex multiple plugs on the same socket. This could generate heat and might cause fire.
• Be sure to use a dedicated power socket with earth wire for the power supply, and connect it to the earth
wire. If the earth wire is not connected, an electric shock or fire may occur.
•
The waste fluid from the printer is a waste oil (waste ink) of industrial waste. Proper waste fluid disposal
according to industrial waste disposal laws and ordinances of your local governments are required.
Consign disposal of waste fluids to specialized processor.
• Do not insert or drop metal or flammable objects into the printer through openings such as a fresh air
inlet. It could lead to an electric shock or fire.
If foreign substances or liquids such as water entered the printer, do not use the printer. It could lead to
an electric shock or fire. Immediately switch OFF the printer, disconnect the power plugs from the
electric socket, and contact your local Océ representative.
•
Pay attention to the following points, while handling the power cables.
o
Do not do anything forcefully on the power cables.
o
Do not keep heavy objects on the power cables.
o
Do not bend, twist or pull the power cables by force.
o
Do not route the power cables near heating appliances.
•
Verify that no foreign substances such as dust are stuck on the power plugs. If you have controlled this,
make sure that the power plugs are firmly inserted to the edge of the power socket.
•
Mishandling of the power cables could lead to a fire.
• Do not operate the media set lever during printer initialization. If the carriage portion and the pressure
roller portion touch each other, there is a possibility that the printer may break down.
•
Do not touch the media feed slot, platen or media guide while heaters are operating. They are hot and
may cause burns.
•
Do not use volatile solvents such as thinner, benzene, or alcohol. These could damage the paint.
• Be careful that moisture does not enter the printer. There is a possibility that the electric circuits inside
the printer might get short circuited.
•
Be sure to switch OFF the power, and disconnect the power plugs when cleaning the printer.