Oce CS9160, User Manual

Page: 12 / 131

User’s Guide Océ CS9160 printer
12 AP-40790 – Rev 2.0 -23/08/2011,
1.4 HANDLING INKS / CL WASTE OF INKS /
CLEANING
Caution
•
Before handling inks/ cleaning and their waste, do carefully read the MSDS-sheet and the
container labels for important health, safety and environmental information.
•
Only use original manufacturer’s ink and appropriate cleaning liquid. Before installing the ink cassette,
shake it gently. Doing so will preserve print quality.
• When an ink cassette is moved from a cold place to warm place, keep the ink cassette for three hours or
more in the new printing environment before printing.
•
Inks
o
General advice: wear safety glasses and gloves especially when handling the waste ink.
o
After spill: remove contaminated clothing.
o
After inhalation: if difficulties occur after vapour/aerosol has been inhaled, remove to fresh air and
seek medical attention.
o
After skin contact: wash thoroughly with soap and water.
o
After eye contact: wash affected eyes for at least 15 minutes under running water while eyelids held
open.
o
After swallowing: rinse mouth and drink plenty of water. Never induce vomiting.
•
Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your skin. Also a
disassembled ink cassette cannot be used.
• When refilling ink, use original manufacturer’s ink cassettes. This printer is designed to use genuine ink
cassettes. If you use ink cassettes which are not produced by the original manufacturer,
o
printing might become blurred and the end of the ink in the cassette might not be detected correctly
o
Any problems caused by using an ink cassette other than those recommended above will not be
covered by the warranty, and repair expenses will be paid by the customer.
• For handling waste : Refer to: section 13 on the MSDS-sheet
General safety instructions that must be observed to use the equipment safely are explained below.
•
Do not install the printer in places where there is a possibility that the printer may be damaged or might
fall by chance. For example:
o
On a shaky stand
o
Slanting location
o
Places where vibration of other machines etc. is transmitted
•
Do not stand on the printer or do not place heavy things on top of it. The printer may be damaged or
might fall.
•
Cover the printer with a blanket or cloth like table cloth and do not close the vent. If the vent is closed,
the printer could accumulate heat inside and may cause fire.
• Do not install the printer in places where the humidity is high or in a dusty environment. It could lead to
an electric shock and/or fire.
•
Do not use damaged power cables. It could lead to an electric shock and / or fire.
•
Do not take out or insert the power plugs with wet hands. This could lead to an electric shock.
• Wire the various cables as explained in the User’s Guide. Wrong wiring could cause fire.
•
Be careful that your fingers are not caught when opening or closing the media cover or front cover.
•
Do not touch the media guide during printing. It is hot and may cause burns.