NSC Sicherheitstechnik GmbH
11/47
2011 / 04 / 26
Eckendorfer Str. 125 c
Installation Manual Solution F2 20110509.doc
33609 Bielefeld
Version S031A01.01
02.4
Switch on/off
from relay : 001 normal
to relay :
↓
+1
↑
-1 Selection -> +10 <- -10
>001 Relay 001 Main processor
002 Relay 002 Main processor
003 Relay 003 Main processor
Cancel On Off Enter
Switching on/off: 6 internal relays
Here the 6 internal relays can be switched on/off.
Relay 1 – 3 : Relais on main board
Relay 4 – 6 : Relais on I/O extension
To switch on/off the relays there are two possibilities
you can choose :
a) To type the relay no. directly by the keypad and
confirming with "OK“. Please use the line “from
relay” and “to relay” for this.
b) Select the relays by using the cursor keys
↓
and
↑
(means 1 line up or 1 line down) or the cursor keys
and
(means 10 lines down or 10 lines up)
and confirm the relay numbers with "Enter“ (F4) or
“OK”. Then press "Enter“ (F4) to confirm the
switching.
The actual „status“of the relay (e.g. normal condition
or active) will be displayed behind the number.
After selection the relay / relays you have to switch
them by pressing F3 ("off“) or F2 ("on“).
02.5
Switch on/off
from power output : 001 normal
to power output :
↓
+1
↑
-1 Selection -> +10 <- -10
>001 Power Output 001 Main processor
002 Power Output 002 Main processor
003 Power Output 003 Main processor
Cancel On Off Enter
Switching on/off: 4 internal power outputs
Here the 4 internal power outputs can be switched
on/off.
Power output 1 – 2 : Power output on main board
Power output 3 – 4 : Power output on I/O extension
To switch on/off the relays there are two possibilities
you can choose :
a) To type the power output no. directly by the
keypad and confirming with "OK“. Please use the
line “from power output” and “to power output” for
this.
b) Select the power outputs by using the cursor keys
↓
and
↑
(means 1 line up or 1 line down) or the
cursor keys
and
(means 10 lines down or
10 lines up) and confirm the power output
numbers with "Enter“ (F4) or “OK”.
The actual "status“of the power output (e.g. normal
condition, fault or active) will be displayed behind the
number.
After selection the power output / power outputs you
have to switch them by pressing F3 ("off“) or F2
("on“).
02.6
Switch on/off
1. Zones & detect. 5. Sounder/Strobe
2. Output 6. Alarm Trans.Dev.
3. Relay 7. Delay
4. Power Output 8. Fire Outputs
Cancel off
"External sounders/strobes" are all power outputs,
relays and outputs, which are configured to
switching function „on/off like sounders“.
Switching on/off: sounders / strobes
After selecting this function in the switch on/off main
menu you see at the bottom line of the LCD „off“
(F3) or „on“ (F2).
By pressing F3 all sounders / strobes will be switched
off continuously.
Pay attention :
By the function (F3) all sounders and strobes will
be switched off continuously. If another alarm
