NS system Tango-B series, User Manual, Page: 85 / 123

No. Name
Description
04 C-04
* INVERTER H/W CHECK
Check the inverter(dc-link) H/W.
Display the peak value of AC voltage input.
The peak value is times as nominal voltage.
Usage : used to check the AC voltage input and inverter H/W.
(Example). If input voltage is AC 220V, it displays "310"
05 C-05
* U PHASE CURRENT SENSOR OFFSET
Check the offset value of U phase current sensor.
It is a substandard device which is more than 60(300mV).
Usage : used to check the current sensor and relative H/W.
06 C-06
* V PHASE CURRENT SENSOR OFFSET
Check the offset value of V phase current sensor.
It is a substandard device which is more than 60(300mV).
Usage : used to check the current sensor and relative H/W.
07 C-07
* U PHASE CURRENT SENSOR
Check the characteristic of U phase current sensor.
Usage : used to check the servo amplifier at factory setting.
08 C-08
* V PHASE CURRENT SENSOR
Check the characteristic of U phase current sensor.
Usage : used to check the servo amplifier at factory setting.
09 C-09
* DEVIATION COUNTER CHECK
Check the deviation counter.
Usage : used to check the servo amplifier at factory setting.
10 C-10
* INPUT CHECK
Usage : used to check the input ports and wiring mistake.
Input selection : Select the input no.(00~13) by
UP/DOWN key.
Selected input no. is displayed.
Status display : The status of selected input is
displayed. (H: ON, L: OFF)
11 C-11
* SYSTEM INPUT CHECK
Usage : used to check the system input ports in servo amplifier.
Input selection : Select the input no.(00~07) by
UP/DOWN key.
Selected input no. is displayed.
Status display : The status of selected input is
displayed. (H: ON, L: OFF)
00 Encoder W phase 04 MPG speed (L=LOW, H=HIGH)
01 Encoder V phase 05 Encoder open (normal=H)
02 Encoder U phase 06 Current limit (normal=L)
03 Over current (normal=L) 07 Encoder Z phase (normal=L)