74
IMS-MN-LMDA42C_A.pdf
Service Address
LMD CANopen
Service Address
If an error cannot be resolved from the information provided in this manual, contact an IMS
Applications Engineer. Have the following details available:
• Nameplate (type, identification number, serial number, DOM, ...)
• Type of error (e.g., LED flash code, error number. etc.)
• Previous and current circumstances
• Assumptions concerning the cause of the error
This information should also be included if returning the product for inspection or repair.
NOTE:
Units being returned for inspection or repair must be accompanied by a Return Material
Authorization (RMA).
Technical or applications support is available via the internet at:
Maintenance
Check the product for dirt, dust, or damage at regular intervals, depending on the way it’s used.
Replacing Units
Drives may perform unintended movements because of incorrect wiring, incorrect settings,
incorrect data, or other errors.
Interference (EMC) may cause unpredictable responses in the system. Further, the behavior of
the drive system is governed by numerous stored data or settings. Unsuitable settings or data
may trigger unintended movements or responses to signals and disable monitoring functions.
WARNING
UNINTENDED MOVEMENT
• Carefully install the wiring in accordance with the EMC requirements.
• Do NOT operate the drive system with unknown settings or data.
• Verify that the stored data and settings are correct.
• Carefully run configuration tests for all operating states and potential error situations.
• Verify the functions after replacing the product and also after making changes to the settings or
data.
• Only start the system if there are no persons or obstructions in the zone of operation.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
Only start the system if there are no persons or obstructions in the zone of operation.
• Switch off all supply voltages. Verify that no voltages are present.
• Label all connections and uninstall the product.
• Note the identification number and the serial number shown on the product nameplate
for later identification.
• Install the new product as per Chapter 4 “Installation” on page 42.
• Commission the product as per Chapter 5 “Configuration” on page 58.
