Norwood Kwik-Pit 26 Series, Operator'S Manual

Page: 61 / 133

4-3
1 - GENERAL INFORMATION
Machine Components
The Norwood Kwik-Pit uses an endless belt that travels in a frame for moving
grain or almost any granular product. The machine is portable for easy moving
and the intake hopper can fit under trucks or low storage facilities.
Normally, this conveyor is used to move material into another conveying
system.
A hydraulic motor, electric motor with wet kit can supply power to the
conveying belt and hydraulic functions located at the discharge end.
Material enters the system through the hopper platform after the hopper sides
are hydraulically raised and exits through the discharge spout.
The jack and hydraulic lift axles are used to raise or lower the frame. The
main components are shown above and on the previous pages in this manual.
Machine Components (Page 2 of 2)
Fig. # 4-2 Machine Components (Electric Drive With Wet Kit)
1 Main Tube 13 Inlet Flashing 25 Drive Over Hopper Hydraulic Cylinder
2 Discharge Spout 14 Lift Axle Hydraulic Cylinder 26 Belt Drive Cover
3 Drive Pulley 15 LH Hopper Flap 27 Discharge Section
4 Conveyor Belt 16 RH Hopper Flap 28 Lift Axle Raise/Lower Lever
5 Drawbar Cage 17 Transition Rollers 29 Hopper Flaps Raise/Lower Lever
6 Hopper Pulley 18 Drive Over Hopper Cable 30 Conveyor Belt Speed Lever
7 Kwik-Pit Hitch 19 Operator’s Manual Canister 31 Return Roller
8 Kwik-Pit Hitch Receiver 20 Intake Section 32 Electric Motor
9 Lift Axle Assembly 21 Lift Axle 33 Hydraulic Fluid Tank
10 Drive Over Ramp 22 Transport Lock 34 Master Disconnect Switch
11 Inlet Cover 23 Discharge Hood 35 Hydraulic Pump
12 Jack 24 Wheel Assembly 36 Hydraulic System Power Lever
2
3
26
23
9
34
27
30
33
29
28
32
24
31
1
10
21
22
19
25
36
35
17
20
14
31
18
16
4
15
10
11
13
6
8
5
7
12
DANGER
MISSING GUARD HAZARD
Machine is shown with guard removed
for illustrative purposes.
• Hydraulic Drive Option: Engage park
brake, place transmission in PARK, shut
off engine, remove key, and wait for all
moving parts to stop before leaving the
tractor cab.
• Electric Drive Option: Turn machine
OFF, shut down and lock out power
source, unplug power cord and wait for
all moving parts to stop before inspecting,
servicing or repairing machine.
• Keep body, hair, and clothing away from
moving conveyor belt and rollers.
• Do not operate with any guards removed
or modified. Keep guards in good working
order. Failure to comply could result in
death or serious injury.
Note:
(Raising Items 15, & 16 LH & RH Hopper Flaps, Form
The Intake Hopper)