Assembly Guide and Owner’s Manual
11
Assembly Steps
Hardware required:
Assembly Step:
(a) button head screw
(b) washers
(c) socket head screw
Tool:
(N) 6mm T-handle hex
key
Qty: 4
Qty: 8
Qty: 4
#1:
Unwind the wire tie from the base of the right upright
and feed it through the large hole. Unwrap the cable
and tie it to the wire tie securely. Draw the tie from
the base bracket.
#2:
Insert a button head screw (a) and a washer (b) into the
top mounting hole on the front panel, and thread the
screw so the other mounting holes line up. Then insert
a button head screw (a) and a washer (b) into the
bottom mounting hole. Fingers tighten.
#3:
Insert two socket head screws (c) and two washers (b) to
secure the upright to the base frame side bracket.
Place each screw on the 6mm T-handle hex key
(N)
and
insert it through the cutout in the upright.
#4:
Attached the left upright following the steps #2 and #3,
using two button head screws (a), four washers (b), and
two socket head screws (c). Fingers tighten.
/ /
0 1 $ 2 3 4 5
a
b
c
1
2
3
Summary of Contents for TA-258
Page 1: ......
Page 11: ...10 Assembly Guide and Owner s Manual Exploded View 1 2 3 4 5 6 7 9 8 10...
Page 38: ......
