Nortel NAC, User Manual, Page: 97 / 132

86 Configuring 10+ nodes
Overview
Standard 1.0 Network Administration Center November 1998
User Guide Supplement
Overview
Introduction NAC 2.5 can monitor up to 20 Meridian MAX nodes. In
previous releases of NAC, you could monitor only 10 Meridian
MAX nodes at the same time.
Note: Although NAC 2.5 is designed to monitor up to 20 nodes,
this number may vary depending on the number of ACD-DNs
equipped within the network. Other network factors may also
influence this number. Consult your Nortel Networks
representative to determine the number of nodes that can you
configure in your network.
When you need
this chapter
You must follow the steps in this chapter if
• you want to add a Meridian MAX 8 (or lower) node to your
node configuration; and
• the node configuration already contains 10 or more nodes
When you do not
need this chapter
You do not need this chapter if
• your NAC 2.5 monitors only Meridian MAX 9 nodes; or
• the node configuration contains less than 10 nodes
Assigning the first
10 nodes The Meridian MAX 8 (or lower) applications are assigned to
one of the first 10 nodes in your node configuration. If Meridian
MAX 9 (or higher) applications occupy the first 10 nodes, you
must delete and reassign one of these applications to another
node position. This chapter describes these steps.