96
Configuring 10+ nodes
Configuring the nodes
Standard 1.0
Network Administration Center
November 1998
User Guide Supplement
Reconfiguring the
node numbers
To print reports that contain the new node and the reassigned
node, you must clean up the existing node configuration and
reconfigure the correct information in the NACD-DN, CDN,
and List Management definitions.
To reconfigure the node numbers, follow these steps.
Starting Point: Parameter Administration submenu in NAC 2.5
10
Select “Save changes and exit.”
Note: The changes take effect after you restart the NAC 2.5
system.
11
Select Network Definition from the Configure NAC System
menu.
Result: The NAC Network Definition/Installation screen
appears.
12
Reenter the node information that you deleted in Steps 5
and 6.
13
Press PF1 to display the Commands menu.
14
Select “Save changes and exit.”
Note: The changes take effect after you restart the NAC 2.5
system.
15
Restart the NAC 2.5 system.
Step Action
Step Action
1
Complete the steps described in the previous procedure
(“Defining the new node” on page 94).
2
Display the Parameter Administration submenu.
Note: For more information on the Parameter Administration
submenu, refer to the Network Administration Guide
Supervisor’s User Guide (P0724352), “Parameter
Administration” chapter.
Summary of Contents for NAC
Page 7: ...viii Contents Standard 1 0 Network Administration Center November 1998 User Guide Supplement ...
Page 8: ...Preface About this guide In this preface Overview x Inside this guide xi ...
Page 96: ...Chapter 8 Configuring 10 nodes In this chapter Overview 86 Configuring the nodes 87 ...
Page 126: ...Chapter 10 Handling error messages In this chapter Overview 116 Error messages 117 ...