42
Using the Meridian Terminal Emulator
Connecting through a serial port or modem
Standard 1.0
Network Administration Center 2.5
November 1998
User Guide Supplement
Connecting through a serial port or modem
Introduction
This section describes how to configure NAC 2.5 to work with
MTE 9 through a serial port or modem.
Setting the
terminal type
To prepare the NAC 2.5 to run with MTE 9, you must set the
terminal type to “MTE 9 or above.”
To set the terminal type, follow these steps.
Starting Point: NAC 2.5 maintenance console
Step Action
1
Verify that the NAC 2.5 system is shut down.
Note: For instructions on how to shut down the system, refer to
the Network Administration Center System Administration and
Maintenance Guide (NTP 553-4011-510), “Maintenance and
administration programs: system running” chapter.
2
Display the NAC Maintenance and Administration menu.
Summary of Contents for NAC
Page 7: ...viii Contents Standard 1 0 Network Administration Center November 1998 User Guide Supplement ...
Page 8: ...Preface About this guide In this preface Overview x Inside this guide xi ...
Page 96: ...Chapter 8 Configuring 10 nodes In this chapter Overview 86 Configuring the nodes 87 ...
Page 126: ...Chapter 10 Handling error messages In this chapter Overview 116 Error messages 117 ...