Nortel NAC, User Manual, Page: 27 / 132

16 Preparing the system
Describing the system requirements
Standard 1.0 Network Administration Center November 1998
User Guide Supplement
Describing the system requirements
Introduction This section describes the hardware and software components
that you require to run NAC 2.5.
NAC 2.5 uses the same hardware components as NAC 2.
However, a new LAN transceiver cable has been added to NAC
2.5.
Equipment and
material list The following table lists the equipment and materials required
by NAC 2.5.
Equipment Contents
NAC 2.5 SNN • Motorola MVME167-34 single board computer with M68040 33 MHz
CPU
• Motorola MVME332XT/XTS eight-channel asynchronous I/O board
(maximum of five)
• NT7D62CA Mass Storage Unit (contains 1 Gbyte hard disk drive and
600 Mbyte tape drive unit)
• NT7D64AA/DC Application Module power supply (AC or DC)
• NTD19SA Application Module
Cables • three multiport cables (NT8D96BE) for each MVME332XT/XTS
asynchronous communication controller
• LAN transceiver cable (NT7D47EA)
• external input/output cables
Workstations • VDT-type (DEC VT520, DEC VT420, DEC VT320, DEC VT220, or
terminals which are 100% compatible
• PC running Reflection 4+ for DOS terminal emulator and directly
connected to the NAC 2.5. All PCs supported by Reflection are
supported by NAC 2.5.
• PC running MTE 9 and connected to the NAC 2.5 (either directly or
through a LAN connection). For more information on PC
requirements, refer to the MTE 9 User Guide (P0881398).