Nortel Meridian 1 Option 11C, Administration And Maintenance

Page: 357 / 507

Chapter 8 — Service changes and maintenance Page 343 of 492
Option 11C ISDN BRI Administration and Maintenance
LD 27 — Removing a DSL
Changing, removing and printing a TSP
Changing a TSP
You can change the characteristics of a TSP on a DSL by specifying the DSL
location and the user service identifier. You can then modify the service
parameters to adapt the TSP to new service requirements for the terminals on
that DSL. If you do not wish to change a parameter, press the Enter key and
the next prompt will appear. When you want to change a TSP, you must
disable the DSL, make the changes to the TSP, and enable the DSL. A
warning message will be displayed and all the active calls on the DSL will be
disconnected.
Note: The DSL must be idle or disabled before proceeding. Use the
STAT c and DISU c dsl# commands in LD 32 to query the status of the
DSL and to disable it.
Prompt Response Comment
REQ OUT Remove an ISDN BRI component
TYPE DSL DSL
DSL cc dsl# DSL location
The values for this prompt are:
cc (card)=1-20
dsl# (DSL location)=0-7