Nortel Meridian 1 Option 11C, Administration And Maintenance

Page: 480 / 507

Page 466 of 492 Appendix A — 2Mb PRI implementation
553-3011-311 Standard 7.0 May 1999
Procedure summary
1 Add a PRI loop. Use Overlay 17.
2 Add a DCHI or DDCH. Use Overlay 17.
Step Overlay Action
1 LD 17 (CFN) Add a PRI loop.
2 LD 17 (CFN) Add a DCHI/DDCH card.
3 LD 15 (CDB) Define a PRI customer.
4 LD 16 (RDB) Define a PRI service route.
5 LD 14 (TDB) Define service channels (B channels) and PRI
trunks.
6 LD 73 (PRI2) Define clock controller parameters.
7 LD 73 (PRI2) Define PRI parameters and thresholds.
8 LD 73 (PRI2) Change trunk pad category values. In most
cases, the settings should be left at their default
values. However, if changes to these values are
necessary, use this step to make them.
Prompt Response Description
REQ CHG
TYPE CFN configuration data block
CEQU YES changes to common equipment
PRI2 XXX where XXX is the DTI/PRI digital card number
(1-9)
MODE PRA select Primary Rate Interface mode
Prompt Response Description
REQ CHG
TYPE CFN Configuration data block
ADAN NEW DCH
1-15
CHG DCH
1-15
Out DCH
1-15 Add a primary D-Channel port number. Any
unused SDI port number
Change a primary D-Channel
Out the primary D-Channel